#Factory reset cisco asa 5505 install#
#Factory reset cisco asa 5505 serial#

At the вЂњErase configuration in flash memory?вЂќ prompt press Enter to confirmД¤. In global config mode: 5505(config)# write eraseДў. The steps I follow to reset the 5505 ASA using the console cable(clearing out the configuration along with any passwords)ДЎ. I then had to use confreg within rommon to set the register to boot correctly. Those register settings didnвЂ™t work in my 5505 ASA and just caused it to boot into rommon.

David Musashi Januat 12:31 Curreri вЂ“ You have to be VERY careful when using those instructions to reset an ASA.

Post navigation в†ђ Installing Plone on Windows and Getting Started Creating an Image with Symantec Ghost 8.0 в†’ This entry was posted in Tech Support, Uncategorized on Januby curreri. Otherwise the default username and password is to leave both blank.

If you had an enable password set, you may need to enter that in the password box when you try to connect using the ASDM.

DHCP is enabled on the cisco device, and itвЂ™s internal IP address is now 192.168.1.1!

The Cisco ASA has been reset to factory settings.

make sure that the outside line is plugged into port zero, and your pc is plugged into any of the ports 1-7.

You want to get back to the prompt that looks like: вЂciscoasa(config)#вЂ™

hit spacebar when the вЂmoreвЂ™ thing happens.

Enter the password, or just press enter if there is no password set.

After you open your connection, press enter a couple times, and you should get a prompt like: вЂciscoasa>вЂ™, or вЂnameofyourdevice>вЂ™.

#Factory reset cisco asa 5505 serial#

Select the radio Type: Serial, then click Serial on the left and use these settings:

#Factory reset cisco asa 5505 install#

Download and install it, then make a new connection. In Windows XP, use hyperterminal, click Start, Programs, Accessories, Communications, Hyperterminal, create a connection on Com1 using the terminal settings:.The console port looks like a network jack, but itвЂ™s above the usb ports. hook up the blue console cable to your serial port, plugging the other end into вЂConsoleвЂ™ port on the ASA 5505.Instead, youвЂ™ll need to use the Console Port! I think will help you fix the problem as much as this button will: This button appears to be entirely for looks. There is a button on the back of the device that says вЂResetвЂ™. If you forgot the enable password, LawrenceвЂ™s commentВ on this page might help. If you can get into the ASDM, it is easier to Reset to Factory Defaults using the CiscoвЂ™s ASDM. If youвЂ™ve mucked up the IP, vlan, etc settings and the Cisco ASDM canвЂ™t get into the device, itвЂ™s time for more desperate measures.

If you are like me, you tend to click things just to see how they work.